Technical features:
- Large-sized cylinder head with large air output: 1020 L/min
- Maxi air stock tank: 650 L (large working range. It allows you to work several hours with the tractor switched off, reducing wear, fuel consumption and noise pollution).
- Maximum pressure: 14.5 bar
- WEIGHT: 380 kg
Details:
REINFORCED SUPER STEEL FRAME: crushproof frame, made entirely of VERY THICK steel, tightly closed and covered.
Guarantees an extremely long service life to the product.
DOUBLE AIR OUTLET SYSTEM:
- One on the right side
- One on the left-hand side
The only air compressor on the market to have two separate air outlet systems from the tank (all compressors on the market, even the largest, only have one)
ADVANTAGES:
- Allows operating multiple equipment at the same time
- Possibility of simultaneous use of equipment with different operating pressure. For example, it is possible to adjust the outlet pressure of one of the two systems to 7 bar and the other to 10 bar.
- Possible simultaneous use of equipment requiring different degrees of lubrication. For example, the pneumatic saw (good lubrication level) together with the pneumatic pruning shears (low lubrication level)
- Need to refill lubricating oil half as often (both lubricators are refilled each time)
2 AIR OUTLET SYSTEMS:
- Glycerine pressure gauge that signals the air pressure inside the tank, thus indicating the status of the air stock
- Heavy-duty pressure regulator MADE IN ITALY with condensate separation filter entirely made in aluminum with glycerine pressure gauge
- No. 01 quick output joint, located before the lubricator
Suitable for all other uses other than agriculture, which normally do not require the introduction of oil into the air through the lubricator (almost no compressor on the market has this additional outlet) - Heavy-duty aluminium lubricator MADE IN ITALY
- No. 04 quick output joints
Air valve at the inlet of each outlet system: it facilitates maintenance operations, such as topping up oil in the lubricator even when the compressor air tank is full.
Operation at low rpm: it only takes about 1200 rpm of your tractor engine to obtain the 1020 L/min of maximum air pumping performance from your compressor cylinder head
Super-robust cooling flywheel made of CAST IRON.
Pulley made of alloy
MODERN MACHINE DESIGN WITH ATTENTION TO DETAILS, as only a large industrial group like Speroni/Airmec knows how to do.
No load operating system and maximum pressure control by means of a professional pilot check valve
No. 02 Standard hose reel supports
Tank drain equipped with valve
THE AIR COMPRESSOR IS SHIPPED ALREADY ASSEMBLED AND READY FOR USE
WARNING: The packaging includes the machine only, without pneumatic equipment (olive harvesters, pruning shears, hoses or other).